Before First Use - TEFAL TRAVEL CITY KO120127 Manual De Instrucciones

• Only plug in your kettle to a
mains socket with an earth pin,
or to an electrical extension with
an earth pin. Check that the
supply voltage indicated on the
rating plate of the appliance
matches that of the system. The
use of multi-plug adapter is not
recommended.
• Never use the kettle when your
hands or feet are wet.
• Place the kettle and its power
cord well to the back of the work
surface.
• Unplug it from the mains socket
immediately if you notice any
anomalies during operation.
• Do not pull on the power cord to
unplug the appliance.
• Do not let the power cord dangle
over the edge of a table or work
top in order to avoid risks of the
kettle falling.
• Always remain vigilant when the
appliance is on, and in particular be
careful of the steam coming out of
the spout which is very hot.
• Do not touch the filter or the lid
when the water is boiling.
• Do not move the kettle when it is
operating.
• Our warranty does not cover
kettles which no longer operate or
operate incorrectly due to a lack of
descaling.
• Protect the appliance from
humidity and frost.
• Keep the kettle and its power
cord away from any source of heat,
from any wet or slippery surface
20
and away from sharp edges.
• Never use the appliance in a
bathroom or close to a water
source.
• All of our appliances are
subjected to strict quality checks.
Operating checks are carried out
randomly on appliances, which
explains why certain appliances
may appear to have been used.
• Always use the filter during
heating cycles.
• Any supply connection error will
negate the guarantee.
Thank you for buying a Tefal kettle.
DESCRIPTION
A. Lid
B. l/0 (ON/OFF) switch
C. LED indicator (depending on
model)
D. Water level gauge
E. Scale filter
F. Voltage selector
G. Power cord clip
H. 2 cups (depending on model)
I. 2 spoons (depending on model)
J. Storage bag (depending on
model)

BEFORE FIRST USE

1. Remove all packaging, stickers
and accessories from the inside
and outside of the kettle.
2. Unwind the power cord
completely (fig 1).
3. Set the voltage selector (F)
(located under the base) (fig. 2)
to the same voltage as that of the