Protection From Overheating; After Cooling; Replacement Of A Blown Fuse; Cleaning Of Projector - Braun PAXISCOPE XXL Manual Del Usuario

Replacement of the auxiliary lamp
The auxiliary lamp should be replaced by a
specialist only.

Protection from overheating

When the equipment overheats the lamps
turn off automatically. Check if the air-intake
opening (13) and the air-outlet opening (14)
are not obstructed!
After the device has cooled down the lamps
turn on automatically.

After cooling

Following prolonged use the cooling system
can continue to operate after the projector
has been switched off. The thermostatic
controlled fans will stop to operate after
some time.

Replacement of a blown fuse

When the device is connected to the mains
and switched on and neither the ventilator,
nor any of the lamps come on then the fuse
has blown.
WARNING: Before the replacement of the
fuse you must disconnect the plug from the
wall-socket!
Turn the fuse holder for a quarter of a turn
and pull out the blown fuse together with its
holder. Replace the fuse with a new one of
the same rating (10A 250V slow).
Should it happen that the just replaced fuse
blows again after the device has been
switched on, take the projector to be
serviced.
Cleaning of the projector
WARNING: Before cleaning disconnect the
plug from the wall-socket!
For cleaning use distillated water or a mild
detergent solution. Use a clean and soft
cloth that will not leave any scratches. Clean
the projection glass (16) and the objective
lens (1) in the same way.
6

Technical Data

Working area:
285×285 mm
3-lens-objective:
2.8 / f=330mm
Halogen reflector lamps:
ENX 82V / 360W (4x)
Auxiliary lamp:
15W / 230V, socket E14, matt
Ø 27 mm, L
max
(i.e.: Osram T26/57 FR15)
Enlargement:
3.5x to 9.5x
Projection distance:
1.5 m – 3.5 m
Size of projected image:
1.0 m – 2.7 m
Mains voltage:
dependant on the model
220V / 50-60 Hz
230V / 50-60 Hz (EU)
240V / 50-60 Hz (UK)
Power consumption:
1500W
Dimensions of the projector:
590×480×330 mm
Weight:
19.5 kg
58 mm,
max