ARIETE Eco Power 2797 Manual De Instrucciones página 13

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
- The filter needs to be re-assembled before the appliance can be used again.
- Insert the filter into the container (E) and lock it into place by turning it clockwise.
- Refit the complete dust container (E) onto the body of the appliance, pressing gently until it clicks
into place, making sure that the air intake on the container has fitted perfectly into its housing in
the appliance bottom (Fig. 9).
Cleaning the air outlet filter
This filter cleans the air one last time before it leaves the vacuum cleaner. To clean the filter proceed
as follows:
- Use the lever to remove the small hatch on the back of the appliance (Fig. 10).
- Clean the filter in cold water and leave it to dry (Fig. 11).
- Refit the clean (or new) air outlet filter into the grid and return this to the appliance, pressing it down
until it clicks into place.
WARninG: only wash the filter in clean water, without using soap or detergents.
WARninG: it is advisable to clean the filter at least every 6 months or in any case, when suc-
tion is visibly reduced.
Cleaning the vacuum cleaner
The casing, dust container and filter seats can be wiped with a damp cloth if necessary. No liquid
must enter the vacuum cleaner in the process. Never use heavy-duty cleaning substances (stain
removers, thinners) because they can corrode the plastic surfaces. Only put the plug back into the
mains socket when you are sure that all parts are thoroughly dry.
IMPORTANT: Do not lubricate or oil any rotating parts, since this could cause dirt and fluff to stick
even further
Cleaning the brushes
While the appliance is switched on, move your hand between the bristles on the brush to free them
of any trapped dust, which will then be sucked into the cleaner.
TROUBLESHOOTING
Thermal cutout switch
The vacuum cleaner is equipped with a thermal cutout switch to protect it in the event that the motor
overheats. If the vacuum cleaner suddenly switches off by itself, proceed as follows:
- Switch off the vacuum cleaner and unplug it from the mains power.
- Look for the origin of the overheating (blocked suction pipe, dirty filter, etc.)
- Clean the hose, empty the dust container and clean the filters, if necessary.
- Wait for about 30-40 minutes to allow the motor to cool down.
- After 30-40 minutes, insert the plug in the mains socket and switch on the vacuum cleaner.
The vacuum cleaner should now work.
- If the vacuum cleaner still does not work, wait another 20 minutes and then try again.
- If the cleaner still does not work, contact an Assistance Centre.
- 11 -
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido