Kingfisher INTERNATIONAL KI9800A Serie Guía De Referencia Rápida página 2

Quick Reference Guide – KI 9800 Optical Light Source
 To remove interchangeable connector adaptor, press the
button on the front of the instrument and pull off adaptor.
 To defeat auto power-off, press and hold [POWER] for 3
seconds during turn on. 'Perm' is displayed on the top right
of the LCD.
 Low battery is indicated with a battery symbol.
 During instrument turn on:
to view all display segments, press and hold [].
-
to display firmware version, press and hold [LEVEL].
-
- to turn buzzer off, press and hold [].
 To enable source emitter, press [] or [] after
turning on instrument. Operating wavelengths will be
shown in the top corner on the right hand side and source
power level on the left hand side. Do not enable a laser
when there is no fibre attached to the optical output
connector.
 To scroll wavelength, press [] or [].
Revision 2 3Sep2013
Page 1 / 14
KINGFISHER INTERNATIONAL
ToneMode:
 Modulation is active only while the source emitter is
enabled. To select a modulation tone, press [MOD] to
scroll through available settings.
 Press and hold [MOD], then press [] to step down or
[] to step up the modulation tone or fiber ID number.
 Press and hold [MOD], then press [] for 3 seconds to
turn off modulation.
 Press and hold [MOD], then press [] for 3 seconds to
advance to ID12.
 To exit, press [MOD] for 3 seconds. Alternatively, press
[POWER] while holding [MOD].
Laser Output Power Adjustment (not available on LED
source)
 To decrease the laser output power, turn the laser 'on',
then press [LEVEL].
 Press and hold [LEVEL], then press [] to step down or
[] to step up the output power.
 Press and hold [LEVEL], then press [] for 3 seconds to
set output power to the lowest level.
English