Aspes ACE648 Serie Manual De Usuario página 34

EN
Do not use any filtering materials not resistant to heat and flame instead of the
existing filter on the product. Do not operate your product without filter.
Power cable should not run near the ranges because it may melt and cause fire
as it would expose to high temperature.
If you operate lamps of the product for a long time, do not touch the lamps.
Lamps may burn your hand as they are still hot.
Unless it is specially specified, never use the hood as a supporting surface. Do
not place any weight on it.
Use the screw supplied with the product for installation or if they are not
supplied then purchase proper type of screws. For installation, use screws with correct
diameter and height as specified in the manual.
Regulations related to exhaust of the outlet air should be observed.
Air should never be exhausted into the flue which is intended for exhaust of the
smokes emitted from the equipment using gas or other fuels to outside (It may not be
applied for the equipment which only recirculates the air in the room). Flue of the hood
should be only for the hood. It should not be used with equipment in common.
Exit of the hood should not be connected to the air ducts where flues of other
types of equipment are located.
When you connect the hood to the flue, use pipe in diameter of 120 mm. For
good performance, the pipe connection should be as short as possible, smooth and with
minimum bends.