Sterilising; Special Cleaning Of Tube And Filter - NUK BP7 Instrucciones De Operación

Ocultar thumbs Ver también para BP7:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 68
18 Protective cap
19 Sealing disc
Warning! Milk residues may
damage the product and result
in microbial growth.
The parts should not be cleaned
Caution!
in a dishwasher – dishwasher detergents
can cause product damage.
Note: When rinsing with dishes (for
example),
certain
discolour the material (e.g. carrot juice) or
affect its odour (e.g. fennel tea). This has
no effect on the fitness for use or safety
of the bottle.
3. Next,
sterilise
"5.2 Sterilising"
4. Wipe the pump unit 3 with a damp cloth.

5.2 Sterilising

Before sterilising, clean as described in the
section entitled "5.1 Cleaning)".
Warning! Risk of scalding during
sterilisation.
Caution!
• For boiling or steam sterilising (temperature
above 80 °C), dismantle into each of its
component parts and leave unassembled,
otherwise deformation can result.
• The pump unit 3, the mains adapter 14 and
the USB cable 15 must never be sterilised
in the above way, as this can damage the
electrical contacts and cause deformation.
• Incorrect treatment can damage the
parts.
• Before using again, allow the sterilised
parts to cool and dry completely before
reassembling.
foodstuffs
all
parts
on page 30).
• When sterilising, do not use any chemical
disinfectants.
!
may
1. Use a NUK Steam Steriliser, following the
operating instructions for the device.
Alternatively,
2. sterilise the parts in boiling water for
5 minutes.
(see
Ensure there is sufficient water in the pan
to avoid product damage.
Alternatively,
3. use
a
Microwave
sterilisation in your microwave oven.
• Only use the NUK Micro Express Plus
Microwave
microwave
operating instructions of the device.
5.3 Special cleaning of tube
and filter
1. If milk enters the tube 4, switch the
device off immediately.
2. Dismantle the device as shown in figure B,
proceeding in reverse from 7 to 1.
3. Remove the filter 6 (see figure C).
4. Clean the following parts with lukewarm
water and a little washing-up liquid and/
or NUK Rinsing Agent:
– rinse filter 6 ;
– flush tube
connector 7.
5. Reassemble according to figure C or B in
reverse order and then use the blow-dry
function
function"
the tube 4 and the push-on tube
connector 7.
30
100°C
5 min
NUK
Micro
Express
Steam
Steriliser
Steam
Steriliser
sterilisation.
4 with push-on tube
"5.4 Tube
(see
on page 31) of the device to dry
Plus
for
for
Follow
the
blow-dry

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido