Tube Blow-Dry Function; Assembling The Pump; Power Supply; Mains Operation - NUK BP7 Instrucciones De Operación

Note: Since the filter 6 would be a virtually
impermeable barrier while wet or damp, it
would inhibit the blow-dry function and the
pump suction. Insert the dry replacement
filter instead. Leave the freshly cleaned and
rinsed damp filter to air-dry for at least
4 hours.
Shake the freshly cleaned filter to remove
most of the water. Then leave the filter,
which is still damp, to air-dry for at least
4 hours.

5.4 Tube blow-dry function

1. Assemble the device as shown in figure B.
Do not insert a filter that is still damp, but
use a dry replacement filter instead.
6.1 To express using one
breast shield
1. Assemble the device as shown in figure B
steps 1 to 7.
Note: Make sure the silicone cushion 11 fits
snugly in the breast shield 10 and the lip

7.1 Mains operation

Warning!
the mains adapter
included
NUK packaging
must be used for
operation
mains power.
To disconnect from the mains supply,
unplug the mains adapter from the socket.

6 Assembling the pump

7 Power supply

Only
in the
from
2. To start the blow-dry function press the
master power switch
simultaneously touch the buttons
and 26.
The blow-dry function runs for 5 minutes.
3. Check that the tube is completely dry (no
droplets visible inside), before starting
the next pumping session.
If the tube is not yet completely dry, start
the blow-dry function again.
You can pause the blow-dry function by
touching the Pause button
continue it later by touching the Pause
button 26 again.
4. To stop the blow-dry function, switch the
pump unit off by pressing the master
power switch
valve 12 is properly mounted, as the pump
can otherwise draw in air, which will prevent it
from working properly.
6.2 To express using two
breast shields
1. Assemble the two breast shields with the
breast milk container as shown in figure
B, steps 1 to 3.
2. Assemble the device as shown in figure
D, steps 1 to 3.
7.2 Power supply via a USB
power source
If no mains power supply is available, you
can supply the breast pump with power
using a USB power source.
The USB power source must deliver an
output current of at least 2 amperes.
• If the power supply supplies a current
less than 2 amperes, an error message
31
27 and then
26 and
27.
23