Berner BOT STARLOCK PLUS Manual Original página 21

Application tool
Scraper, flex-
ible
Bi-metal seg-
ment serrated
blade
TC-Riff sanding
finger
TC-Riff plunge
cut saw blade
HCS universal
joint cutter
Bi-metal plunge
cut saw blade
for wood and
metal
Bi-metal plunge
cut saw blade
for wood and
metal
TC plunge cut
saw blade,
metal
HCS plunge
cut saw blade
for wood
Fitting/changing the application tool
Remove the application tool if one has already
been fitted.
To do so, open the SDS lever (4) all the way. The
application tool/accessory will be ejected.
Position the required application tool (e.g. plunge
cut saw blade (9)) on the tool holder (5) so that
the depressed centre is facing downwards (see
1 609 92A 4DC • 13.12.18
Material Application
Carpet adhesive, Flexible scraping on a soft surface;
paint residue, silic- example: Removing silicone joints, carpet ad-
one hesive residue and paint residue
Insulation material, Precise cutting of soft materials;
insulation boards, example: Cutting insulation boards to size, cut-
floor panels, impact ting protruding insulation material to length so
sound insulation that it is flush with the surface
boards, cardboard,
carpets, rubber,
leather
Wood, paint Sanding of wood or paint in hard-to-reach
areas without sanding paper;
example: Sanding off paint between window
shutter slats, sanding wooden flooring in
corners
Fibreglass, mortar, Plunge cuts in extremely abrasive materials;
wood example: Routing of thin mosaic tiles
Expansion joints, Cutting soft materials;
window putty, insula- example: Cutting silicone expansion joints or
tion materials (rock window putty
wool)
Softwood, hard- Fast, deep plunge cuts in wood and metal;
wood, veneered example: Fast cutting of wood containing nails,
boards, plastic- deep plunge cuts in laminated boards and pre-
coated boards, non- cise shortening of door frames
hardened nails and
screws
Wood, abrasive Fast, deep plunge cuts in wood, abrasive
wood-based materi- wood-based materials and plastics;
als, plastics, example: Fast cutting of non-ferrous metal
hardened nails and pipes and profiles with small dimensions, easy
screws, non-ferrous cutting of non-hardened nails, screws and
metal pipes steel profiles with small dimensions
Stainless steel, Fast, deep plunge cuts in severely abrasive
screws and nails, materials or metal;
epoxy resin, fibre- example: Fast cutting of kitchen front covers,
glass-reinforced easy cutting through hardened screws, nails
plastics, fibreglass, and stainless steel.
plasterboard, porous
concrete
Softwood, dowels, Fast, deep separating cuts and plunge cuts;
pins, furniture ele- including sawing close to edges in corners and
ments in difficult-to-reach areas;
example: Deep plunge cut in softwood for in-
stalling a ventilation grille
figure on the graphics page, text on the applica-
English
tion tool should be legible from above).
When doing so, place the application tool/access-
ory in a position which is convenient for the job at
hand. Twelve positions offset by 30° are possible
for this.
English | 21