Power Failure; Energy Saving Tip - Danby DCFM171A1WDB Manual Del Usuario

CARE & MAINTENANCE
CLEANING
Ensure the appliance is unplugged before cleaning.
• To clean the inside of the appliance, use a soft
cloth and a solution of a tablespoon of baking
soda to one quart of water or a mild soap
solution or some mild detergent.
• Clean the outside with a soft, damp cloth and
some mild detergent.
• It is important to keep the area where the lid
seals against the cabinet clean to ensure a tight
seal. Clean this area with a soapy cloth. Rinse
with a damp cloth and let dry.
Note: Do not use cleaners containing ammonia or
alcohol on the appliance. Ammonia or alcohol can
damage the appearance of the appliance. Never
use any commercial or abrasive cleaners or sharp
objects on any part of the appliance.

POWER FAILURE

Most power failures are corrected within a few
hours and should not affect the temperature of your
appliance if you minimize the number of times the
lid is opened. If the power is going to be off for
a longer period of time, take the proper steps to
protect your contents.
Note: Wait 3 to 5 minutes before attempting
to restart the refrigerator if operation has been
interrupted.

ENERGY SAVING TIP

The appliance should be located in the coolest area
of the room, away from heat producing appliances,
and out of direct sunlight. Do not overload the unit
or block any ventilation openings.
VACATION
• Short vacations: Leave the appliance operating
during vacations of less than three weeks.
• Long vacations: If the appliance will not be used
for several months, remove all items and turn off
the appliance. Defrost, clean and dry the interior
thoroughly. To prevent odour and mold growth,
leave the lid open slightly, blocking it open if
necessary.
MOVING
• Remove all items.
• Tape the lid shut.
• Be sure the appliance remains in the upright
position during transportation. Protect the
outside of the appliance with a blanket.
• If the appliance is placed on its back or side
during transportation, upon reaching the
destination, allow it to remain in its operating
position for 6 hours to avoid damage to internal
components.
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling
of electrical components. For information on local
waste collection points, contact your local waste
removal agency or government offi ce.
Disposal of this appliance should be in accordance
with federal and local regulations.
7