ASROCK H61 Pro BTC Manual De Instrucciones página 20

2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATA2_0: see p.2, No. 12)
(SATA2_1: see p.2, No. 15)
(SATA2_2: see p.2, No. 11)
(SATA2_3: see p.2, No. 14)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 18)
(9-pin USB8_9)
(see p.2 No. 17)
Infrared Module Header
(5-pin IR1)
(see p.2 No. 13)
20
SATA2_0 SATA2_2
SATA2_1
SATA2_3
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
ASRock H61 Pro BTC Motherboard
These four Serial ATAII
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII hard disk or the
SATAII connector on this
motherboard.
Besides six default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
This header supports an
optional wireless transmitting
and receiving infrared module.