Klark Teknik VNET Guia De Inicio Rapido página 14

26
VNET ETHERNET INTERFACE
Accessory Racking Kit
The Ethernet Interface may be used free-standing or 19" rack mounted using the optional rack
mounting kit. This kit comprises of a panel which can accommodate up to three accessories
(the Accessory Power Supply being another example) in 1U of rack space. Unused positions
are neatly blanked-off . The supplied brackets make the process of mounting the accessories
quick and easy.
1. Remove the two mounting brackets and Lexan blanking sheet which are covering the
aperture you wish to mount the accessory in, by removing the two nuts. (Keep these and the
screws and washers).
2. Remove the two screws from one side of the accessory.
3. Using the two screws removed in 2, attach one mounting bracket loosely to the side of the
accessory, with the "ear" towards the front, pointing outwards.
1. Repeat 2 and 3 for the other side. Now push the lid towards the back of the unit as far as it
will go then align the bracket ears with the front edge of the lid. Now tighten the screws.
2. Offer the accessory with its mounting brackets up to the reverse side of the Mounting Panel,
and fix it in place using the two sets of screws, washers and nuts removed in 1.
Note that the holes at the rear ends of the brackets may be used as cable tie-off points
if desired.
27
Quick Start Guide