Publicidad
1. Main window panel and extension panels (extends from 20"
up to 46") ......................................................... 3 pieces
2. Exhaust nozzle with diameter 130mm.....................1 piece
3. Exhaust nozzle with diameter 110mm.....................1 piece
4. Screws..............................................................8 pieces
5. Exhaust hose with diameter 130mm (large)............. 1 piece
6. Exhaust hose with diameter 110mm (small)..............1 piece
7. Cover ...............................................................2 pieces
8. Foam............................................................... .2 pieces
9. Hose connector (air outlet) for large hose with dia.130mm ....
........................................................................1 piece
10. Hose connector (air intake) for small hose with dia. 110mm
........................................................................1 piece
Installation
1) Connect the 3 pieces of window panels (No. 1) by sliding 2 extension panels into the
main window panel.
2) Apply a foam strip (No. 8) to each end of extension panels.
3) Open the window and place the window panel assembly into the window. Adjust the
extension panels to fit the width or height of the window as shown below ( figure A).
Secure the extension panels by using 4 blunt tip screws (No. 4, figure B-1). Secure the
main window panel by using 4 pointed screws (No. 4, figure B-2 and B-3).
4) Expand the 2 ends of large exhaust hose (No. 5). Connect the hose connector (No.9) to
one end of the exhaust hose (No. 5) by turning clockwise. Then insert the exhaust
nozzle (No. 2) at the other end of the exhaust hose by turning clockwise (figure C) to
create the hose assembly.
5) Insert the connector end of the hose assembly (step 4) into the rear of unit and turn
clockwise to secure (left side of figure D).
6) Insert the exhaust with nozzle (step 4, the hose assembly) end into the window panel
(figure E)
7) Expand the 2 ends of small exhaust hose (No. 6). Connect the hose connector (No.10)
to one end of the exhaust hose (No. 6) by turning counterclockwise. Then insert the
exhaust nozzle (No. 3) at the other end of the exhaust hose by turning counterclockwise
(figure C) to create the hose assembly.
8) Sliding in the connector end of the hose assembly (step 7) to the rear of unit (right side
of figure D).
9) Insert the exhaust with nozzle (step 7, the hose assembly) end into the window panel
(figure E)
10) Plug the power cord into the wall outlet and press "Reset" button.
11) Please allow 8" of space around the unit for proper circulation.
12) When removing the portable air conditioner for storage, the window panel may be
left in place. Simply place the covers (No.7) over the nozzle holes (see diagram 3 of
figure 3) to close the openings.
1
2
5
6
9
10
3
4
7
8
Publicidad
