Product Appearance; General Safety Information - HJM 625 Instrucciones De Uso

Product Appearance

FRONT

General Safety Information

When using electrical appliances, basic
reduce the risk of fire, electric shock and injury to person, including the following:
1. Read all instructions before using heater.
2. Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electrical shock, or injury to persons.
3. Make certain that the power source conforms to the electrical requirements of the
heater.
4. Extreme caution is necessary when any heater is used by or near children or inva-
lids and whenever the heater is left operating unattended.
5. Where possible, avoid the use of extension cords because the extension cord may
overheat and cause a risk of fire.
6. Do not operate any heater with a damaged cord or plug or after the heater malfunc-
tions, has been dropped or damaged in any manner. Return heater to authorized
service facility for examination, electrical or mechanical adjustment or repair.
7. Unplug power cord before servicing or moving the heater. Always unplug heater
when not in use.
WARNING: DO NOT DEPEND ON THE ON/OFF SWITCH THE SOLE MEANS OF
DISCONNECTING POWER WHEN SERVICING OR MOVING THE HEATER.
ALWAYS UNPLUG THE POWER CORD.
8. Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust
opening as it may cause an electric shock or fire or damage the heater. Do not block
or tamper with the heater in and manner while it is in operation.
E N G L I S H
REAR
precautions should always be followed to
–13–
A. WARM OUTLET OPENING
B. BASE WITH TIP-OVER SWITCH
C. BODY
D. METAL MESH
E. CONTROL PANEL
F. HANDLE
G. AIR INLET OPENING
H. PLUG
I. POWER SWITCH
E
N
G
L
I
S
H