Preparation Before Use - Lanaform Stim Mass Manual De Instrucciones

EN FR NL DE ES IT PL CS SK SL HR BG SV AR
weak, stop using the device immediately and
raise your legs up (for 5 to 10 minutes).
• It is best not to coat your skin with greasy creams
or ointments before a treatment as this signifi-
cantly increases wear on the electrodes or may
cause unpleasant current spikes.
DAMAGE
• If the device is damaged, if in doubt, do not use
it and contact your dealer or the address given
for after sales service.
• Check the device for signs or wear or damage.
If the device shows such signs or if it has been
misused, it must be sent to the manufacturer or
taken back to the dealer before being used again.
• Switch off the device immediately if it is faulty or
not working properly.
• In no event try to open and/or repair the device
yourself! Repairs must only be carried out by the
after sales service or approved dealers. Failure to
comply with this instruction will void the guarantee.
• The manufacturer is not responsible for damage
caused by incorrect or improper use.
INFORMATION ON ELECTROSTATIC
DISCHARGES (ESD)
• Caution, plugs with the danger of electrostatic
discharge symbol on them must not be touched.
• Protection measures against electrostatic discharges:
· Do not touch plugs or sockets with the danger
of electrostatic discharge symbol on them with
your fingers!
· Do not touch plugs or sockets with the danger
of electrostatic discharge symbol on them with
manual tools!
• More detailed explanations on the danger of
electrostatic discharge symbols, as well as pos-
sible information and its content, are available
on request from the after sales service.
DEVICE DESCRIPTION, 1, 2
1 ON/OFF switch
2 Cord connection plugs for power supply
3 Timer (5 to 15' – display of time remaining)
4 Massage mode selection
5 Impulse intensity
6 2x holders for self-adhesive electrodes
6 / 80
Stim Mass - LA100206 - 001 - 2017 - Notice - K - 1.0.indd 6
/
Stim Mass EN Instruction manual
7 4x self-adhesive electrodes
8 2x power cords
9 Belt clip holder
10 Battery compartment
11 Timer function (display of time remaining)
12 Battery charge status
13 Choice of mode (suction, kneading, pressing,
massage, combination of 4 modes)
14 Intensity display
USE

PREPARATION BEFORE USE

• The Stim Mass operates with 2 AAA 1.5V batteries
(not supplied). Before using your device, check that
these are correctly inserted in the compartment
provided. ( 1 10)
• Before turning on your device, connect the power
cord ( 1 8) to the electrodes ( 1
• Place the electrodes so that they surround the
muscle segments concerned. For optimum effec-
tiveness, the distance between the electrodes must
not be more than about 15 cm. The electrodes must
not be used on the anterior chest wall. This means
that the device should not be used to massage
the left/right pectoralis major muscle.
• The Stim Mass is equipped with 2 stimulation
channels and four electrodes which enable work-
ing on two areas of the body at the same time.
DIAGRAM FOR POSITIONING THE
ELECTRODES, 2, 3
When using the Stim Mass and when you apply the
electrodes, the use of two electrodes per muscle
group is recommended.
• To obtain the stimulation's desired effect, it is
important to place the electrodes carefully. We
advise you to decide on the optimum positions
for the electrodes in the desired application area
with your doctor.
• The positions of the electrodes suggested above
are given for reference.
• The following comments are applicable when
choosing the electrodes' positions:
DISTANCE BETWEEN ELECTRODES
• The greater the distance chosen between the
electrodes, the greater the volume of stimulated
7).
12/07/2017 12:16:38