Uline SCOTT PRO H-9550 Guia Del Usuario página 2

3. Align dispenser on wall with previously drilled holes.
Insert four screws. (See Figure 3)
LOADING THE DISPENSER WITHOUT A STUB ROLL
1. Load towel roll into the upper roll holders. Ensure that
the paper feeds down from the back. (See Figure 4a)
2. Lift the black transfer bar and place the leading
edge of paper under it. Lower the transfer bar.
(See Figure 4b)
Figure 4a
Black
Transfer Bar
3. Press the feed button until the paper exits the
module.
4. Tear off paper and close cover securely.
NOTE: Once cover is closed, there is a
four-second delay before unit is activated.
LOADING THE DISPENSER WITH A STUB ROLL
1. When main roll reaches approximately 2.6" in
diameter, the "Low Product" light will begin to flash,
indicating the roll may be moved to the stub roll
position.
PAGE 2 OF 15
MOUNTING CONTINUED
LOADING
Figure 4b
Feed
Button
Figure 3
2. Without disengaging sheet from drive mechanism,
remove stub roll from upper roll holders and
temporarily hold in front of the upper roll holders.
(See Figure 5)
Figure 5
3. Lift the gray transfer bar so it is positioned against
the back wall of the dispenser. (See Figure 6)
Figure 6
Gray
transfer bar
4. Load the stub roll into the lower roll holders.
0921 IH-9550