Operation - ATH-Heinl 7226 Manual Del Usuario

1.3

Operation

1.3.1 Review of the different functions
Before using the tyre changer, check all functions with the operating part to ensure the machine is working
properly. This should be done before mounting.
1.3.2 Precautions during tyre assembly
Before mounting the tyre, the following precautions must be observed:
Only mount undamaged, clean, dry rims and tyres that are in good condition.

 Remove old balance weights.
Check rim and tyre for damage, especially aluminium rims. Do not mount if damaged.

Check that the rim and tyre size match.

 Before dismantling, let all air out of the tyre.
 Before mounting, coat the rim and tyre well with tyre lubricant to avoid damage.
Always use a new valve.

The tyre changer is not splash-proof, so do not clean wheels on the machine with water jets.

® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
WARNING!!
When operating the mounting machine, pay attention to all moving parts.
Make sure there is enough safety clearance. Make sure there are no other
people in the work area.
WARNING!!
Always keep enough safety clearance when loosening the mounting arm so
that it does not tilt outwards under tension.
WARNING!!
Ensure that there are no persons or objects in the working area of the
machine.
WARNING!!
When closing the jaw chuck, the process must be stopped immediately when
the minimum position is reached.
When tightening the rim, stop immediately when the maximum pressure is
reached. For aluminium rims, check the clamping pressure and set it lower if
required.
Failure to comply with this instruction may result in serious damage to the
mounting machine.
Manufacturer ATH-Heinl GmbH & CO.KG
- 6 -