Important Safety Instructions For Installation And Use; Assembly And Installation; Electrical Connections; Assigning An R. F. Radio Receiver - Mottura 1804E35D Manual De Instrucciones, Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
I
MPORTANT SAFETY INSTRUCTIONS FOR INSTALLATION AND USE
The installation and electrical connections must only be carried out by qualified technicians, with suitable
equipment and under safety conditions, following the instructions given in this manual.
The system must be installed so that the motor unit is at a minimum height of 2.5 m above ground (or from the
nearest access surface).
The button that operates the system must be installed outside operating area, at a minimum height of 1.5 m
above ground (or from the nearest access surface) and within sight of the system.
All routine or extraordinary maintenance must be performed solely by qualified technicians after disconnecting the
system from the electrical power supply.
If any work needs to be done occupying the system operating space (e.g. cleaning glass, removing fabric, etc.)
prevent all possible activation of the system operating devices or disconnect the system from the electrical power
supply.
Only original parts must be used if any parts need to be replaced. Any use of non-original parts and any
adaptation or tampering will relieve Mottura S.p.A. of all liability for injury to persons or damage to property.
Do not let children play with the operating devices. Keep the devices out of their reach.
Make periodic checks of all mechanical and electrical parts. Take steps to prevent the system from being used if
maintenance has to be done.
During normal system use, monitor its movement. Prevent anyone from entering the system operating space until
it is completely stopped.
Attachments "A" – "B" provides instructions for correct assembly and installation of the tubular motors Ref.
1804E35D(T), Ref. 1805E35D(T), Ref. 1804E45D(T) and Ref. 1805E45D(T).
The motor must be connected to the electrical grid, to the drive devices, and to any
outside units by trained personnel only.
DO NOT work on the motor when it is powered. Before doing any work, disconnect the
system from the electrical grid in such a way that it stays disconnected until all work is
finished.
Attachments "C" – "D" – "E" provide instructions for correct connection of the tubular motors with the "2 + 3 wires"
method (power supply and controls in separate systems). In this case, you can create single or simultaneous
controls via wire.
Note:
Do not extend the bus line wires.
always isolate each wire of the bus line.
If not used, isolate each wire of the control line
To control the Ref. 1804E35D(T), Ref. 1805E35D(T), Ref. 1804E45D(T) and Ref. 1805E45D(T) by radio it must be
assigned to a remote control. To perform this operation carry out the following procedure:
1. Put the transmitter into the association mode (consult the technical manual of the transmitter being
used).
2. Press the R.F. button/led on the motor head for 3 seconds
the motor and an orange flashing of the LED confirm that the association procedure has been carried out
correctly.
6
A
SSEMBLY AND INSTALLATION
E
LECTRICAL CONNECTIONS
SAFETY RULES
A
R. F.
SSIGNING AN
En 2
Z393 rA
RADIO RECEIVER
(see attachment "F")
. A "click/clack" issued by

Publicidad

Tabla de contenido
loading

Tabla de contenido