Placing Tool In Service - Ingersoll Rand 2131 Manual De Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll- - Rand No. 50
Ingersoll- - Rand No. 115- - 1LB for routine external
lubrication of the impact mechanism through the Hammer
Case Grease Fitting.
Use Ingersoll- - Rand No. 105- - 1LB or Ingersoll- - Rand
105- - 8LB when disassembling and assembling the impact
mechanism.
Always use of an air line lubricator. We recommend the
following Filter- - Lubricator- - Regulator Unit:
For International - - C16- - C3- - A29
For USA - - No. C11- - 03- - G00
Do not mark any nonmetallic surface on this tool with
customer identification codes. Such actions could affect
tool performance.
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by the
hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pres-
sure.

PLACING TOOL IN SERVICE

WARNING
WARNING
WARNING
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905- -1)