Date Of Manufacture - Suunto DW141 Manual De Usuario

7.6 Display
Display backlight is on by default. The brightness of the display can be adjusted
under General » Device settings » Brightness. The default value is 50%. Adjusting
this value has direct impact on battery life.
TIP: You can significantly extend battery life by turning down the display
brightness.

7.7 Date of manufacture

The manufacturing date can be determined from your device's serial number. The
serial number is always 12 characters long: YYWWXXXXXXXX.
In the serial number, the first two digits (YY) are the year and the following two
digits (WW) are the week within the year when the device was manufactured.
8 COMPLIANCE
8.1 CE
Hereby, Suunto Oy, declares that the radio equipment type DW141 is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address: suunto.com/EUconformity.
8.2 EU depth gauge standard
The European depth gauge standard EN 13319:2000 is applicable to the Suunto
EON Steel product. The notified body no. 0078, Institut National de la Plongée
Professionnelle, Entrée 3 Port de la Pointe Rouge, 13008 MARSEILLE, France, has
tested the Suunto EON Steel product according to this standard.
8.3 FCC / ISED regulatory notices
Modification statement
Suunto has not approved any changes or modifications to this device by the
user. Any changes or modifications could void the user's authority to operate the
equipment.
Interference statement
This device complies with Part 15 of the FCC Rules and Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the
device.
Wireless notice
This device complies with FCC/ISED radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines and RSS-102 of the ISED radio frequency (RF) Exposure rules. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
12