Replacing Thread Spools; Cloth Waste Cover - Texi Tegra 4 Manual De Instrucciones

REPLACING THREAD SPOOLS

CLOTH WASTE COVER

Remove the Cloth waste cover: Remove the waste box,
open the looper cover. Press on the Cloth waste cover with
left thumb and separate the cover from the machine, then
pull out hard with left hand and remove the Cloth waste
cover. See above pictures.
Texi Tegra 4 INSTRUKCJA 2019.indb 85 Texi Tegra 4 INSTRUKCJA 2019.indb 85
When replacing thread spools, the
following steps may be helpful for quick
changeover.
1. Cut off existing threads near the spools.
Tie the cut ends thread from new spools
(seamen's knot).
2. Raise presser foot.
3. Lower needle bar to its lowest position
by turning hand wheel away from you.
Carefully pull the existing threads until
the connecting knots pass through
needle eye and looper eyes.
Cloth waste cover is used for
collecting the cloth waste
into the waste box during
sewing, avoiding cloth
waste entering the inside of
the machine.
Texi Tegra 4
Install the Cloth waste cover:
Push the Cloth waste cover
under the looper cover hard
with left hand and snap onto the
buckle A firmly.
EN
85
18.09.2020 09:42 18.09.2020 09:42