Presser Foot Lifter Lever; How To Adjust The Presser Foot Pressure; Replacing Presser Foot - Texi Tegra 4 Manual De Instrucciones

EN

PRESSER FOOT LIFTER LEVER

Presser foot lift lever can be used
to raise or lower the height of
presser foot. When the height is
adjusted to a maximum of 6 mm,
you can sew very thick fabric.
Once the stitch is formed, if you
want to continue sewing, do not
have to raise the presser foot lift
lever. Use your fingers to gently
lift the presser foot and push the
fabric under the raised presser foot. step pedal speed controller, fabric will be sewing.

HOW TO ADJUST THE PRESSER FOOT PRESSURE

REPLACING PRESSER FOOT

NOTE: TURN OFF THE POWER.
1.
Turn the hand wheel toward you
to raise the needle to its highest
position. Raise the presser foot.
2. Press the lever on the back of the
presser foot holder. The presser foot
will drop off.
3.
Place the presser foot so the pin on
the foot lies just under the groove of
the holder.
4. Lower the presser foot holder to lock the foot in place.
As shown in the figure, the dial (See fig "A") on the presser foot is used to indicate
the range of motion of the needle
86
Texi Tegra 4 INSTRUKCJA 2019.indb 86 Texi Tegra 4 INSTRUKCJA 2019.indb 86
The pressure of the machine is readjusted for sewing medium
weight fabrics. It may be necessary to adjust the pressure to sew
different weights of fabrics by turning the pressure regulationg
screw (use screwdriver S). For light weight fabric - decrease pressure.
For heavy weight fabric - increase pressure.
Texi Tegra 4
18.09.2020 09:42 18.09.2020 09:42