Placing A Call; Receiving A Call - Plantronics CA10 Manual De Usuario

CA 10Gray2 Body.r2 12/12/01
STEP 2

PLACING A CALL

With your headset in position, place the handset off-hook.
Press the Talk Button on either the Remote
The In-Use Indicator Lights
1 14
will light and you will hear a dial tone.
If you do not hear a dial tone, move the Configuration Switch
to the opposite setting (A or B). If you still do not hear a dial tone,
see Troubleshooting on page 11.
Dial a co-worker. When your party answers, speak normally.
If you do not sound loud enough, move the Transmit Level
Switch to position 1 or 2. If you sound too loud, move the
20
Transmit Level Switch to position 2 or 3. You can further fine tune
the transmit level with the Talk Volume Control
Adjust the volume of your co-worker's voice by using the Listen
Volume Control .
10
Replace the handset upon completion of the call and press the
Talk Button on either the Remote
In-Use Indicator Lights will go out.
1 14
6:50 PM Page 8
or the Base Unit .
2 18
on the Remote and Base Unit
21
.
16
or the Base Unit . The
2 18
8
STEP 3

RECEIVING A CALL

With your headset in position, when your telephone notifies you of
G
an incoming call, place the handset off-hook.
E Press the Talk Button on either the Remote
The In Use Indicator Lights
Replace the handset upon completion of the call and press the Talk
Button on either the Remote
Indicator Lights
1
STEP 4
F
PAGE FUNCTION
E
If someone at the Base Unit needs to summon you, pressing
the Page Button momentarily causes the Remote to emit two
17
long, loud beeps.
If you have misplaced the Remote, press the Page Button
seconds and the Remote will emit a steady alert. Press the Talk
Button once you have located the Remote.
2
or the Base Unit
2
will go on. Begin speaking.
1 14
or the Base Unit . The In-Use
2 18
will go out.
14
9
G
.
18
E
E
D
for 3
17