Cosatto nitty gritty wow Manual De Instrucciones página 6

Fitting & Operation Information:
Please refer to the following diagrams:
Chassis
Front wheel
Rear wheel
Brake
Front wheel swivel
lock
Basket
Chassis
Carrycot
Carrycot hood
Carrycot
Carrycot apron
Raincover
Seat unit
1- Opening:
Release the auto lock (1) and lift the handle upwards until the chassis locks into
position (2).
Check the chassis has locked in place.
2- Adjusting handle position:
3- Fitting:
4- Removing:
5- Fitting:
6- Removing:
7- Applying:
8- Releasing:
9- Applying:
10- Releasing:
11-
Front pocket (1). Rear pocket (2). Drinks holder (3).
12- Closing:
Note: The chassis cannot be closed with either the carrycot or the child car seat fitted.
To close with seat unit fitted, the seat unit must be forward facing and in the most
upright recline position.
While pressing the primary release button (1), pull both secondary levers (2) back.
Press down on the handle (3) until the autolock retains the chassis in the folded
position (4).
13- Preparation:
Remove mattress and liner from carrycot (1).
Unfold both frame bars until they locked into positions (2).
14-
Refit the liner into the carrycot (1) and secure the zip fasteners (2).
Refit the mattress over the liner in the carrycot (3).
There are a set of "D" rings located at the base of the carrycot for the attachment of a
separate safety harness approved to BS EN 13210 should this be required (harness not
supplied). Push the "D" rings through the slots in the liner (4).
15- Opening:
16- Closing:
17- Note: The carrycot can only be fitted rearward facing as shown in illustration.
18- Fitting:
Dots are marked on the chassis mounts and carrycot mounts (1). These should be on
the same side and aligned if fitted correctly.
19- Removing:
Open the carrycot hood 15 .
Press the release button on top of the hood frame (1).
Lift the carrycot off the chassis (2).
20- Fitting:
Removing is a reversal of this procedure.
21- Fitting:
Removing is a reversal of this procedure.
22- Using access zip:
23- Accessing handle:
24- Note: The seat unit can be fitted forward or rearward facing.
25- Fitting:
26- Removing: