Vortice VORT PRESS 110 LL Folleto De Instrucciones página 8

ENGLISH
!
Precaution:
• Do not make any modifications of any kind to your
product.
• The appliance must not be exposed to atmospheric
conditions (rain, sun, etc.).
• The product must only be installed by a qualified
technician.
• Perform periodic inspection on the unit to see that it
is free of visual defects. If any are found, do not
operate the unit and immediately contact Vortice.
• The electrical mains to which the unit is connected
must conform to current standard.
• The appliance must not be used to activate water
heaters, stoves, etc., nor must it extract to their hot-
air conduits.
• Since the appliance is double insulated, it does not
need to be earthed.
• The electrical power source to which the product is
to be connected must be able to provide the
maximum amount of electrical power required by the
product. If it cannot do this, contact an electrician for
appropriate remedial action.
• When installing the appliance, a multipolar switch
must be used. The switch interpole distance must be
no less than 3 mm.
• The temperature of the air or fumes being extracted
must not contain any greasy substances, soot,
chemical agents, corrosive agents, or mixtures that
are explosive or inflammatory.
• The appliance must exhaust either directly to the
outside or into a duct reserved solely for the
appliance.
• Effective appliance operation requires adequate
room-air replenishment. Moreover, if there is also a
water heater, gas stove, etc. drawing its air for
combustion from the same room, room-air
replenishment must be increased to allow all
appliances to work effectively.
VORT PRESS 110 LL
The power-source data must be consistent with the
electrical data shown on the nameplate (A).
8
this symbol indicates that care must be taken to avoid damaging your product
• Do not cover or obstruct the unit's air intake and
outlet grilles.
• The appliance must be installed so that its impeller
is out of reach on the outlet side (as determined by
the Standard Finger Test, Fig.B) in conformance
with the current safety regulations
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by a qualified
engineer.
• Should the appliance fail to operate or not operate
correctly, turn the switch to off. Contact Vortice
immediately and, if repairs are required, make sure
that original Vortice parts are used.
• Turn off your appliance when your are not using it.
• When removing the unit for storage, first turn off the
main switch, then disconnect the electrical cord from
the wall socket, and then store it in a place which is
inaccessible to children and inexperienced persons.
• The product with timer starts 40 seconds after
ignition and stops after 2 minutes of operation.
It is possible to change this time by operating on the
trimmer (see fig. 17 and following).
• The product has 2 speeds (minimum and
maximum). The product with timer functions at its
maximum speed when the lamp is switched on, and
at its minimum speed when the lamp is switched off
(fig. 8). It is possible to insert a switch for speed
selection(fig.9): when the lamp is switched on
(switch B) it functions at its minimum or maximum
speed, when the lamp is switched off it always
functions at its minimum speed.
• The timer adjustment must be carried out by a
qualified person.
• NOTE. When the wall or tile surfaces are uneven,
use a spacer when mounting the extractor unit
to avoid operation vibration and noise.
VORT PRESS 140 LL - 220 LL
The power-source data must be consistent with the
electrical data shown on the nameplate (A).