Performing A Functional Test - Dometic MWE7006 Instrucciones De Montaje Y De Uso

Performing a functional test

Suppressing use of a bicycle rack or trailer
I
NOTE
You can program PIN 17 either for switching over the stop zones or for
deactivation when using a trailer.
You can use an external switch (not included in the scope of delivery) to:
• Switch over the standard stop zone (parameters 47, 48 and 49) to a higher stop
zone (parameters 61, 62 and 63) if you are using a bicycle rack and this is being
folded out.
• Deactivate the parking aid while you are using a trailer.
To do this, proceed as follows:
➤ Connect pin 17 of the connection cable plug to earth using the external switch.
➤ For trailers only: Set parameter 56 to 00.
Suppressing the display of a trailer coupling or an external spare wheel
➤ Set the parameters 51, 52 and 53 to suit your trailer coupling or your spare wheel.
12 Performing a functional test
Conduct the functional test of the sensors as follows:
➤ Switch on the ignition and engage the reverse gear.
Be very careful when you operate the device for the first time, and make sure that you
familiarize yourself with the various sequences of beeps.
!
WARNING!
In zone 4, some obstacles may not be detected, because they are no
longer within range of the sensors (design-related characteristic).
12
MWE7006
EN