Publicidad
Idiomas disponibles
Idiomas disponibles
Illustration 4
Wire guide
frame
Illustration 5
Illustration 6
Flush mounting
bracket
Desk
Leg bracket
Leg bracket
screw
42-2538M
SIDE 2 OF 3 (1/06)
DESK AND RETURN
Cut-out in interior
wall of pedestal
Desk top
Flush mounting
bracket
Screws from
bottom of
desk top
Screws from bottom
of return top
Screw
Tie bracket
Detail A
Wire Guide Frame Installation (refer to Illustration 4):
1. Locate cut-outs on the pedestal(s)
2. Install a wire guide frame onto cut-out in interior wall
(kneespace) of pedestal(s).
Flush Return Installation:
1. Use two or more people to position desk where it will be
used and adjust leveling glides to level desk front-to-
back and side-to-side.
2. Use the
/
" hex head screwdriver to remove screws and
1
4
flush mounting bracket from bottom of return unit. Save
screws and mounting bracket for later use.
3. Use the
/
" hex head screwdriver to remove five screws
1
4
along front bottom edge of desk top, next to outboard
panel. Save screws for later use.
4. Refer to Illustration 5. Install mounting bracket, removed
from return unit, onto the bottom of desk top as shown
(note hole pattern). Use the
reinstall screws, removed from bottom of desk top, and
tighten securely.
5. Refer to Illustration 6. Use the
to remove screws from desk outboard panel front leg
bracket. Align holes in tie bracket with holes in leg brack-
et and reinstall screws (Detail "A", Illustration 6). Tighten
screws securely.
Return
6. With return in the upright position, rest top of return onto
flush mounting bracket attached to desk. Align rear edge
of return top with side edge of desk top. Use the
head screwdriver to reinstall screws removed from return
but do not fully tighten screws.
7. Refer to Illustration 6. Use the
er to install screw (from hardware pack) through hole in
bottom edge of skirt and into tie bracket (Detail "A",
Illustration 6). Do not fully tighten screw.
8. Adjust leveling glides to level return front-to-back and
side-to-side and checking alignment of return and desk,
use the
/
" hex head screwdriver to fully tighten all
1
4
screws.
.
/
" hex head screwdriver to
1
4
/
" hex head screwdriver
1
4
/
" hex
1
4
/
" hex head screwdriv-
1
4
Publicidad
