Publicidad
PORTERO DIGITAL - DIGITAL DOOR ENTRY SYSTEMS - PORTIER NUMÉRIQUE
INSTRUCCIONES DE PROGRAMACIÓN DE TELÉFONOS/SOPORTES DE CONEXIONES
INSTRUCTIONS FOR PROGRAMMING TELEPHONES/CONNECTION BRACKETS
INSTRUCTIONS DE PROGRAMMATION DES TÉLÉPHONES/SUPPORTS DE CONNEXIONS
Program the telephones/connection brackets connected to each AIB-001 one by one, as
shown below.
PASOS DE PROGRAMACIÓN
1
2
3
STEP-BY-STEP CONFIGURATION
1 Set microswitch 1 of the SW1 switch of the first AIB-001 to the ON position.
2 Program the telephones/connection brackets from the main entrance panel (see
the data sheet for the telephone/connection bracket). Bear in mind that the range
of values possible depends on the type of installation (see page 14).
3 Set microswitch 1 of the SW1 switch of the first AIB-001 to the OFF position.
Repeat these steps for each AIB-001 in turn.
ETAPES DE CONFIGURATION
1
2
3
Publicidad
