cabstone EASYSCOPE L Manual página 6

Manual
wall. If the structure of your wall is different, corresponding installation material must be
used. In any case, consult a specialist.
• Make sure to observe the correct thread size during installation of the display screen to
the wall bracket.
5 Installation:
ATTENTION! Only trained professionals are authorized to inspect the wall, as well
as install and remove the product! For more information please read the Chapters
"Notes on Safety" and "Troubleshooting".
Wall Installation:
Step 1
Please use the wall bracket (A) as template to mark 6 holes to be drilled in the wall using
a level (4 on top, 2 at the bottom). There must be a horizontal distance of 150 mm
between the drilled holes. Check, if gas or water pipes, or power lines are behind the wall
before drilling. Use a 10 mm stone drill to bore the holes with a depth of 60 mm. Insert
one dowel (F) into each of the drilled holes. Now, use the 6 wall screws (E) and 6 suitable
washers (M/L) to attach the wall bracket (A).
Installation of Screen Bracket:
Step 2
As illustrated in Figure 2, stay bars (D) must
be inserted through screen bracket (B) and
screen holder (C), make sure the stay bars
are centered. Use the fastening rails (R) and
the fastening bolt (P) to fasten the screen holder to the stay bars, as illustrated in the
Figures 3-A and 3-B. Then, please compare the construction with Figure 3-C.
Attaching the Display Screen to Screen Bracket:
Step 3
ATTENTION! Do no tighten the fastening bolts so that screen holders can still
slide on the stay bars to be able to change their position. Screen holders may
not exceed the edges of stay bars, and all 6 fastening parts must be tightened
for secure attachment.
Check which of the supplied screws match the threads of your display screen. Short
screws are for display screens with flat rear side. Long screws should be used with
spacers (O) M4/M5, or (N) M6/M8, and are provided for display screens with curved rear
side. Long screws should only be used without spacers, when threads of display screens
are very deep. Figures 4-9 serve as guideline to chose screws for attachment to the
screen bracket.
10
10-11
Hooking onto Wall Bracket
After you have attached the screen bracket and screen holders to
your display screen, hook the display screen on the wall bracket as
illustrated in Figure 10. When the display screen hangs safely on the
wall bracket, you must use the pre-installed screws (U) to connect
the wall bracket with the screen bracket. You can use the thumbnut
on the wall bracket to adjust the angle of inclination of the display
screen.
The installation is completed. Please proceed in reverse
order for disassembly.
6 Warranty and Liability:
• The manufacturer warrants this new device for 2 years.
• As the manufacturer has no influence on the wall type and the installation of the wall
installation kit, warranty of the product only applies to the installation kit.
• If any fault or damage is detected on your device, please contact your dealer and provide
your sales slip or invoice as evidence of the purchase, if necessary. Your dealer will
repair the fault either on site, or send the device to the manufacturer. You make the work
of our technicians considerably easier, when you describe possible faults in detail – only
then you can be assured that faults occurring only rarely will be found and repaired with
certainty!
• If your dealer cannot be contacted, you can also contact us directly.
• The manufacturer is not liable for damages to persons or property caused by improper
installation or operation not described in this guide. This includes, among others, any
alteration and modification of the product and its accessories.
• Any use other than described in this user's guide is not permitted, and causes loss of
warranty, loss of guarantee, and non-liability.
• We reserve our right for misprints and changes of the device, packing, or user's guide.
TM
Step 4
NOTE:
11
04.05.2010 16:06:36