3. Secure the device to the base in the
recommended position.
4. Carry out the device connection to the system.
The end of a stranded conductor must
not be consolidated with mild soldering
in the points in which the conductor is
subject to contact pressure.
5. Carry out the device confi guration by means of
jumpers and/or dip-switches.
6. Replace the terminal strip cover on the device
(the second transparent cover should not be
used because it prevents cover closing.)
7. Power on the device.
8. Complete the confi guration of the parameters
as shown in the introduction.
The Urmet CallMe App confi guration
manual is available on the www.urmet.
com website or by scanning the QR
code at the end of the section.
9. Install the cover.
DS1083-127
If, at a later stage, it becomes necessary
to remove the cover use a screwdriver in
the indicated points.
2
3.3. DESCRIPTION OF
COMPONENTS
1
2
5
3
1. STATUS LED: LED showing the state of your
Internet connection.
•
fl ashing red light: the device is turned on in
the confi guration mode;
•
steady green light: the device has been
correctly registered with the Urmet SIP
server and is ready to forward calls to a
smartphone;
•
steady red light: the device is showing that
there is no Internet connection;
•
steady orange light: device not enabled (no
active Wi-Fi.).
During power-on or after pressing
the PROGR/RESET key, the device
will need 50s to start up; during this
time, the LED will remain off.
2. PROGR/RESET key: by pressing the button
for a time
•
comprised between 2s and 4s, the device
will restart in the confi guration mode
1
2
1
4
6
7
8
5