Maxon C2 Instrucciones página 15

CAUTION
Do not use a battery charger for
connecting power to Liftgate power
cables.
1. Connect power from a 12 volt truck battery
to the Liftgate power cables extending from
the back of main frame housing.
2. Refer to operating instructions, in C2
Operation Manual, to unfold platform
and activate the Liftgate.
NOTE: With the POWER ON and
LIFTGATE ACTIVATED lights
on, the Liftgate can be raised
or lowered. If the Liftgate is not
used for 90 seconds, the control
will automatically deactivate.
3. Use the control switch to lower (DN) the
platform to the ground (FIG. 15-1).
4. Unbolt and remove main frame housing
cover (FIG. 15-2).
5. Remove the small parts and manual
kit from the housing. Refer to Sheets
3 & 4 for contents of the kits.
LIFT CORPORATION Sht. 15 of 55 DSG#
PREPARE LIFTGATE FOR WIRING
M-15-02
USING CONTROL SWITCH
TO LOWER LIFTGATE
FIG. 15-1
5/16" FLAT WASHERS
COVER
REMOVING HOUSING COVER
FROM C2 LIFTGATE
FIG. 15-2
Rev. E Date: 09/13/21
5/16" HEX NUT,
(3 PLACES)