Battery Charge - miniland baby digimonitor 3.5 touch Manual Del Usuario

ENGLISH
BATTERY INSTALLATION (FIGURE C)
1. Unscrew and remove the cover from the battery compartment (11) on the back of the unit.
2. Insert the Li-ion battery (supplied).
3. Replace the battery cover and secure it with the screw.
Caution: Use only batteries of the recommended type because, otherwise, there is risk of
explosion. Dispose of used batteries responsibly.
Note: The parent unit is equipped with a battery saver function in order to prolong battery
life. When not using the two units, it is recommended to turn them off in order to save
battery.

BATTERY CHARGE

Insert the rechargeable battery according to the instructions in the previous section.
There are two different methods for recharging the battery:
1. Connect the power adapter to the mini USB socket on the side of the unit (16). Use only the
adapter supplied. Plug the adapter into the mains.
2. Using a mini USB-USB cable (not included), connect your monitor to the USB port of a
computer. If the computer is on, the charging process will start directly.
Note: remove the battery when you are not going to use the appliance for a long time.
5.1.2. BABY UNIT POWER SUPPLY
The camera or baby unit of this baby monitor is designed to be used with the AC/DC
adapter supplied.
1. Locate the connector socket (VIII) on the back of the baby unit.
2. Connect the adapter cable to the mini USB socket of the camera. Use only the adapter
supplied.
3. Plug the adapter into the mains.
Warning: Choking hazard – Keep the cord out of the baby's reach. NEVER place a camera
with cables less than 1 meter from the cot. Never use extension cords with AC adapters.
Use only the AC adapters supplied.
5.2. OPERATION
5.2.1. TURNING THE UNITS ON/OFF
5.2.1.1. MONITOR:
Hold down the power button (6) located at the top of the monitor to turn it on or off. The ON/link
LED (1) light up or go out depending on whether you turn the unit on or off.
5.2.1.2. CAMERA:
To turn the camera on or off, hold down the power button (III) for two seconds. The power LED
(IX) will light up or go out depending on whether you are turning the unit on or off.
When you have installed and turned on the camera, you can view the images and hear the
sounds picked up in your baby's room through the monitor.
5.2.2. TOUCHSCREEN LOCK
If you need to lock the touchscreen to prevent any function being activated when not desired,
press the screen lock button (12) on the side of the monitor. Press this button again if you wish
to reactivate it.
5.2.3. TALKING TO THE BABY
From the parent unit, you can talk to your baby (e.g. to reassure him/her and let them know you
are on your way) or partner (if he or she is in the baby's room).
Press and hold down the button for talking to the baby (13) and speak into the monitor. Release
the button when you finish talking to hear the sound from the baby's room again. Note that you
33