Motor Feedback Wiring - Exlar EXP-24 Manual De Instalación Y Servicio

Motor Feedback Wiring

The Exp 24 Controller provides interface circuits for a resolver and a thermistor used for motor position
feedback and temperature monitoring. These are low voltage analog signals; therefore a quality
shielded cable must used. The cable should have 4 twisted pairs with individual foil shields with drain
wires as well as an overall braided shield. The drain wire for the individual pair shields should be
connected only on the EXP 24 end, no connection on Actuator end, while the overall braided shield
should be connected to the housings on both ends, ideally through the cable gland. The terminals will
accept wires ranging from 24 AWG to 12 AWG (0.08 – 2.5 mm
EXP- 24 Control
Cos Shield
Cos Low
Cos High
Sin Shield
Sin Low
Sin High
Ref Shield
Ref Low
Ref High
ACT Temp Shied
ACT Temp
ACT Temp
Cos Shield
Cos Low
Cos High
Sin Shield
Sin Low
Sin High
EXP 24 Manual
PN 47676
Revision H
20 ft. max
Braided Shield
Motor Feedback Cable
Function Terminal
J16
J18
J17
J13
J15
J14
2
).
Function
Ref Shield
Ref Low
Ref High
ACT Temp Shied
ACT Temp
ACT Temp
49
EL 100 Actuator
Cos Low
Cos High
Sin Low
Sin High
Ref Low
Ref High
ACT Temp
ACT Temp
Terminal
J12
J11
J10
J21
J19
J20
1/9/14
Exlar Corporation
952-500-6200