Installation Instructions; Wall Installation - turbionaire MIO 100 Manual De Instrucciones

INSTALLATION INSTRUCTIONS

Caution: make sure power is switched off at service panel before starting installation.
note :the location of installation must be near a socket outlet. a licensed electrician will be required to install the
socket outlet.

WALL INSTALLATION

1. Ensure to choose right voltage shown in the label before connecting with power source.
2. Cut an appropriate size hole in the wall, ensure there are no cables or pipes burned in the wall when cutting. The
internal and internal wall flush, allow the ducting to slope slightly to the external wall, this will allow drain­ age of
any ingress from rain.
3. Remove the front cover of fan and position the fans against the wall and
mark the four fixing points and cable entry, then to drill to suit.
4. Bring the cable to the unit via a double pole switch with a minimum 3mm separate on all poles.
5. Bring the main cable through the cable entry and fix the fan body into position.
6. Fix the front cover and external shutter (External shutter not supplied)
10