General Information; Safety Warnings; Installation Instructions; Use And Maintenance - Emax BCF640 Manual De Utilización

Plano vidrioceramica
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
EN
VITROCERAMIC HOB
User instructions

GENERAL INFORMATION

Carefully read the contents of this leaflet since it
provides important instructions regarding safety of
installation, use and maintenance.
Keep the leaflet for possible future consultation.
All the operations relating to installation (electrical
connections) must be carried out by specialised
personnel in accordance with current regulations.

SAFETY WARNINGS

It is recommended to use flat-bottom pans with a
diameter equal to or slightly larger than that of the
heated area Fig.3.
Do not use pans with a rough base in order to prevent
scratching the heat surface of the cooking hob.
This appliance is not suitable for use by children or
persons requiring supervision.
IMPORTANT
- Avoid spilling liquid, therefore to boil or heat liquids,
reduce the heat.
- Please ensure when the appliance is turned on, that
there are no empty pots left on top.
- When you have finished cooking, switch off the
relevant heating element with the command indicated
hereinafter.
h
WARNING
If the surface of the hob is cracked, turn off the
appliance and disconnect from the electrical main in
order to avoid any possible electric shocks.

INSTALLATION INSTRUCTIONS

These instructions are for a specialized installer and
are a guide for the installation process, regulations and
maintenance in accordance with the law and current
standards.
POSITIONING
The domestic appliance was built in order to be
encased on a work surface, the way it is illustrated in
the graph (fig.1A).
Predispose sealing material (fig.1D) along the whole
perimeter (the dimensions of the cut Fig.1A).
Lock the domestic appliance into place with 4
supporters (fig.1B), keeping in mind the width of the
surface (Fig.1C).
ELECTRICAL CONNECTIONS (fig.2)
Before making the electrical connections, check that:
- the system ratings meet the ratings indicated on
the identification plate fixed on the lower part of the
worktop;
- the system is fitted with efficient ground wires in
accordance with the laws and current standards.
Grounding is mandatory by law.
h
If the domestic appliance is not supplied with a cable
and/or suitable plug, use material suitable for the
absorption value indicated on the identification plate
and the operating temperature.
At no point must the cable reach a temperature of 50°C
higher than room temperature.
If wishing to make a direct connection to the mains, an
omnipolar switch must be installed with a minimum 3
mm opening between the contacts and appropriate for
the load indicated on the plate and in accordance with
current standards (the yellow/green ground conductor
must not be disconnected by a switch).
When the appliance has been installed,the omnipolar
switch must be easily reachable.

USE AND MAINTENANCE

MAINTENANCE
Remove any residues of food and drops of grease
from the cooking surface by using the special scraper
supplied on request (Fig.4)
Clean the heated area as thoroughly as possible using
suitable products, and a cloth/paper, then rinse with
water and dry with a clean cloth.
Using the special scraper (optional) immediately
remove any fragments of aluminium and plastic
material that have unintentionally melted on the heated
cooking area, or residues of sugar or food with a high
sugar content (Fig.4).
This way, any damage to the cooktop surface can be
prevented. Under no circumstances should abrasive
sponges, or corrosive chemical detergents, such as
oven sprays or stain removers, be used.
USE
Rotate the controls placed on the oven, taking into
consideration that to a higher number corresponds a
higher heat supply
The pilot lights are ON when:
- at least one element is inserted.
- the top tenperature at the Indicated spot is higher
than 50°C.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE),
requires that old household electrical
appliances must not be disposed of in the
normal unsorted municipal waste stream. Old
appliances must be collected separately in
order to optimise the recovery and recycling of the materials
they contain and reduce the impact on human health and
the environment. The crossed-out dustbin symbol on the
product reminds you of your obligation regarding separated
waste collection. Consumers should contact their local
public service or their local dealer for more information on
the correct disposal of exhausted household appliances.
THE
MANUFACTURER
RESPONSIBILITY FOR EVENTUAL DAMAGES
CAUSED BY BREAKING THE ABOVE WARNINGS.
DECLINES
ALL
5

Publicidad

Tabla de contenido
loading

Tabla de contenido