Publicidad
Idiomas disponibles
Idiomas disponibles
1
E
Assemble a
Star Washer, a
Flat Washer and a
shown.
3
Turn the Retaining Pin until the office panel is held snugly
between the Retaining Pin and the Panel Hanger; tighten the
Knob (finger-tight only!).
5
Complete by inserting a
into the threaded hole below the bottom stud of the Panel
Hanger, and tighten. Do both Panel Hangers.
7
N
Insert Removable
front "W" loop on the Base; tilt the Divider up slightly, slide the Divider back, and lower the Divider until its back leg fits behind the
wire in the backmost loop of the Base.
4100-37: 2 of 4: Rev. 4; 9/11
F
Retaining Pin, a
H
D
Knob to each
Panel Hanger, as
H
G
F
E
I
Screw through the keyhole
Dividers into 2-Slot Sorters: the hook at the lower front corner of the Divider fits into the open trough of the
N
2
G
Hang the Panel Hangers over the office panel, spacing them
apart to match the spacing between the keyholes in the
GridWall
TM
D
4
Slide the keyholes in the GridWall
studs on the Panel Hangers, then slide the Back Panel down
securely. (Note: the GridWall
at one of three heights: top keyhole on bottom stud, or top
two keyholes on both studs, or bottom two keyholes on both
studs.)
6
Hang individual items where desired. Note: for proper
support, do not hang any individual items from the lowest
thin wire of the GridWall
I
DON'T USE BOTTOM WIRE!
Back Panel.
Back Panel over the
TM
Back Panel may be mounted
TM
Back Panel.
TM
M
Publicidad
