Descargar Imprimir esta página

Technical Specifications - Miniland DIGIMONITOR 3.5 TOUCH Manual De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
Problem
You cannot charge the
battery in the parent unit
If the Baby Unit has lost
its link with the Parent
Unit
6. MAINTENANCE
· Clean the surfaces of the camera and monitor with a soft, lint-free cloth.
· If the units become dirty, use a lightly dampened cloth to wipe surfaces, taking care to not allow water into any
openings.
· Never use cleaning agents or solvents.

7. TECHNICAL SPECIFICATIONS

Frequency
Operating Range
Nº of configurable channels
Nº of automatic channels
Power (parent unit)
Rechargeable battery for monitor
Power (baby unit)
Operating time with battery fully
charged (parent unit)
Jack to RCA compatible adaptor cable format
MiniUSB-USB compatible cable
8. INFORMATION ON THE DISPOSAL OF BATTERIES AND PRODUCT
· Remember to remove the batteries and dispose of them in a responsible manner when disposing
of the baby monitor.
· You should not mix products bearing the crossed-out rubbish bin symbol with your domestic rubbish.
· These products should be taken to the collection points allocated by the localauthorities for
appropriate treatment.
Alternatively you may contact the point of sale where you purchased the product.
Hereby, Miniland S.A. declares that this 89175 digimonitor 3.5" touch is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
Possible Cause
The AC/DC adapter is not
plugged in
A non-rechargeable battery
has been used
The camera and monitor may be
too far apart
The link between both units has
been lost momentarily
The link between both units has
been lost
Solution
Plug in the adapter
Only rechargeable batteries can be used
(3.7 V, 1200 mAh Li-ion battery): check the
battery and if necessary replace it with the
one supplied with the appliance
Move the monitor closer to the camera
Reset the units by disconnecting them from
the electrical power. Wait about 15 seconds
before reconnecting. Allow up to one minute
for the Baby Unit and the Parent Unit to
synchronize.
Pair the camera and monitor again. See
5.2.6.8.1.
2,4 GHz DIGITAL (FHSS)
Up to 230m (straight line and open space)
4
24
Input: 100-240 VAC 50/60Hz 300mA
Output: 5V DC 800mA
1 x 3.7 V, 1200 mAh rechargeable Li-ion
Input: 100-240 VAC 50/60Hz 300mA
Output: 5V DC 800mA
Continuous use 5 hours
Figure D
USB cable for data transfer
33
ENGLISH

Publicidad

loading

Este manual también es adecuado para:

89175