Connection To Power Supply - KRONAsteel INGA 600 push button Guia Del Usuario

EN Application sheet
the second end of the flexible air duct to the
ventilation opening.
Avoid excessive bends of the air duct. The
shorter and straighter the air duct is (with no
unnecessary bends), the higher is the hood ef-
ficiency, and the lower are the noise and vibra-
tions.
7. Should you select the recirculation mode, there
must be coal filters installed onto the motor
case (not included). In this mode it is not re-
quired to mount the air duct onto the hood.
8. Prior to installation of decorative duct, bring
out the wire to connect the hood to the mains.
9. Insert the inner decorative duct into the exter-
nal one. Lift the internal duct to align attach-
ment points of the duct and strip, connect them
using screws (Fig. 16).
KITCHEN HOODS

CONNECTION TO POWER SUPPLY

The kitchen hood is connected to the power net-
work with the voltage of 220-240V, 50 Hz.
The kitchen hood should be connected to a wall
outlet with earthing to avoid electrocution.
It is absolutely prohibited to cut off the plug
during kitchen hood installation.
The damaged electrical cord should be re-
placed by a qualified service specialist.
For additional protection of the kitchen hood from
voltage drops in the network, connect it though an
additional automatic switch 6A.
Switch it on and use it as you please.
The kitchen hood is installed.
13