Dometic CAM 44 Instrucciones De Montaje página 18

Notes on the electrical connections
• Protect every through-hole made in the bodywork against water penetration,
e.g. by using a cable with a sealant and by spraying the cable and the cable
sleeve with sealant.
I
NOTE
Only start sealing through-holes when you have completed all
installation work on the camera and have laid the required cable lengths.
7.2 Using branch connectors
To prevent loose connections in the branch connectors, it is important to ensure that
the cable cross sections fit into the branch connectors.
To use the branch connectors, proceed as follows:
➤ Insert the cable to be tapped in the front groove of the cable connector
(fig. a A, page 6).
➤ Insert the end of the new cable up to approx. 3/4 of the way into the rear groove
(fig. a B, page 6).
➤ Use a pair of combination pliers to close the connector by pressing the metal pin
in. This creates an electrical connection (fig. a C, page 6).
➤ Press down the safety cap until it snaps into place.
➤ Check that the connection is secure by gently tugging the cable (fig. a D,
page 6).
18
CAM44
EN