Troubleshooting - Everbilt SSB300 Guía De Uso Y Cuidado

Troubleshooting

Problem
The pump does not start or run.
The pump operates but pumps little or no
water.
Possible Cause
1. The fuse is blown.
2. The breaker is tripped.
3. The plug is disconnected.
4. The plug is corroded.
5. There is thermal overload.
6. The motor failed.
1. The screen is blocked.
2. The impeller is loose on the shaft.
3. The impeller is broken.
4. The pipe or hose is loose.
5. There is air lock.
8
Corrective Action
1. Replace the fuse.
2. Reset the breaker.
3. Secure the plug.
4. Clean the plug prongs.
5. Unplug for 30 minutes and then plug
in again.
6. Replace the pump.
1. Clean the screen.
2. Reassemble the impeller.
3. Replace the impeller.
4. Secure the pipe or hose.
5. Drill a 1/8 in. hole between the check
valve and pump discharge.