Connecting A Master Valve - Hunter X-CORE Manual Del Usuario

CONNECTING A MASTER VALVE

NOTE: Complete this section only if you have a
master valve installed in your irrigation system. A
master valve is a "normally closed" valve installed at the
supply point of the main line that opens only when the
controller initiates a watering program.
1. At the Master Valve, attach the common wire to either solenoid
wire of the valve. Attach a separate control wire to the remaining
solenoid wire.
2. The common wire should be attached to the C terminal inside the
controller. The other wire coming from the master valve should
be attached to the P terminal inside the controller. Tighten each
terminal screw.
24VAC SEN C P 1 2 3
BAT
Master
Valve Wire
Master Valve
4 5 6 7 8
Valve Wires
Valve Common Wire
EN
Valve 4
Valve 3
Valve 2
Valve 1
11