Tools Required - Whittier Wood Products 628W Instrucciones Para Armar

ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Head Screwdriver, Tape Measure, Hammer, Wood Glue.
We recommend finishing the unit before final assembly. Before finishing, read enclosed finishing
hints.
NOTE: Due to the fact that more than one type of hardwood is used, we recommend testing for desired
color. To test for desired color on:
a) Veneer parts – apply stain to unexposed portion of side panel. See FIGURE 1.
b) Alder pieces – apply stain to back of base. See FIGURE 4.
O
O
V
M
P
STAIN TEST AREA
1) Install two Drawer Slides (Cabinet Side Left – T2) using #6 x 5/8" Undercut Screws (O) in the two
sets of prepunched holes in the Left Side (F). Insert a third screw in one of the center holes in each
of the slides. See FIGURE 1A.
Repeat for the Right Side (G) with Drawer Slides (Cabinet Side Right – T1).
Hammer Tack Glides (P) into the bottoms of both sides about one inch from the front and back
edges. See FIGURE 1A.
Glue two Dowels (V) into the dowel holes in each Side.
Insert a Cam Connector (M):
into each of the six holes in the bottom of the top (I).
into the hole in each lower corner of both Sides (F & G) below the dowels.
PAGE 4 — 628W
628W File Cabinet
O
O
O
O
V
O
O
O
M
P
P
FIG. 1A
IMPORTANT:
The side panels have a compression
stamp on the bottom edge:
"L" for left, "R" for right.
O
O
V
M
P
M
M
M
FIG. 1B
The drawer slides will be stamped with an "L" for left or
an "R" for right in the center of the wheels.
Or they will be stamped about 3" from the wheel with:
"CL" for cabinet Left; "DL" for drawer left; "CR" for
cabinet right; "DR" for drawer right.
M
M
M