Garland SET 752 G Manual De Instrucciones página 39

other dangerous chemical substances. In case of gas
concentration due to insufficient ventilation, eliminate
from the work area everything that impedes the
correct flow of air and do not work in this area again
until it is well ventilated and the gas concentration
does not happen again.
Work only with good light. Do not use this machine at
night, with fog or with reduced visibility that does not
allow you to clearly see the working area.
Avoid operating the equipment in wet grass, where
feasible. Take special care when using this machine
in the rain or after rain because the ground is slippery
and you can slip.
If you lose your balance or fall, let go of the handle
switch immediately.
Do not use this machine if you are tired, sick, are
taking medicines, or if under the effect of alcohol or
drugs.
Do not use this machine when you are tired or
under the influence of drugs, alcohol or medicines. A
moment of distraction when using this machine can
cause severe personal damage.
The lack of rest and fatigue can cause accidents and
damages.
Never cut above shoulder level.
Do not get near the cutting elements of the machine
when the machine is functioning.
Do not rely solely on the security elements of the
machine.
It is important to check that all parts are well
tightened. If you detect any anomaly, stop the machine
straight away and check the machine carefully. In
case of any damage, take the machine to your nearest
service agent. Never carrying on working if the
machine is not working correctly.
Remember to always use the machine with clean
hands and without petrol and oil.
Clean the work area and eliminate any obstacles
that could cause accidents. Check the work area and
remove any objects that could get entangled to the
cutting elements. Also remove any objects that could
be expelled by the machine or its parts when getting
in contact with these.
Do not allow anybody to enter the working area.
This working perimeter is 15 metres and this is a
dangerous zone.
Never use the machine when on top of a ladder, in a
tree or in any other unstable surface.
When moving from one working area to the next, turn
off the engine.
Never let the machine unattended.
Never touch elements that can be hot during
the start up or operating the machine, for
example, the escape, sparks or high voltage cables.
Do not use any accessories that are not originals
and that have not been recommended by the
manufacturer.
Use of other accessories can cause accidents and can
be dangerous for the end user and those nearby as
well as causing damages to the machine.
Always follow the security rules that we indicate in the
manual.
39/144
English