Troubleshooting Guide - BH FITNESS H855 Manual De Instrucciones

G.BODY-FAT FUNCTION
This monitor has a memory to record SEX (Male
– Female); HEIGHT (100 – 199.5 cm); WEIGHT
(10 – 199.8 kg); AGE (10 – 99). The first time
the monitor is switched on, values of gender,
heigth, weigth and age will be introduced and
memorized for the PULSE RECOVERY test. To
change these values follow the next steps:
1. Press any key to switch the monitor on.
2. Press the ENTER/RESET key for more than
6 seconds and the male figure will start
flashing, use the UP or DOWN keys to select
Male or Female
ENTER/RESET key.
3. Use the UP – DOWN keys to select your
height and press ENTER/RESET key.
4. Use the UP – DOWN keys to select your
weight and press ENTER/RESET key.
5. Use the UP – DOWN keys to select your age
and press ENTER/RESET key.
6. Press the BODY FAT key and place both
hands on the hand-grip sensors (R) and
certain characters (
appear on the screen displaying your BMR
(Basal Metabolic Rate, values between 1 –
9999), BMI (Body Mass Index, values
between 1.0 – 99.9), FAT% ( Body fat %,
values between 5 – 50%), and the values will
be shown on the bottom screens.
NOTE:
If the error code "E1" is shown on the screen
then this means that you do not have your
hands positioned correctly on the hand-grip
sensors (R).
Personal data is not stored and will be lost when
the monitor is reset or switched off.
Refer to the following table to gauge your BODY
FAT status:
REFERENCE TABLE: BODY FAT
PERCENTAGE %
SEX / LOW LOW /
FAT% AVERAGE
MALE < 13%-25.8%
13%
<23% 23%-35.8%
FEMALE
REFERENCE TABLE: BMI
THIN= NORMAL+ SLIGHTLY
OVERWEIGHT
<18.5 =18.5~24.9 =25~30
and press the
) will
AVERAGE HIGH
26%-30% >30%
36%-40% >40%
OVERWEIGHT
<30
BODY TYPES:
There are 9 body types based on the
percentage of fat calculated.
TYPE 1 Extremely athletic
TYPE 2 Ideal sportsman
TYPE 3 Very slender
TYPE 4 Sportsman
TYPE 5 Ideal health
TYPE 6 Slender
TYPE 7 Very overweight
TYPE 8 Overweight
TYPE 9 Extremely obese

TROUBLESHOOTING GUIDE

Problem: The display comes on but only the
Time function works
Solution:
a.- Make sure that the connection cable is
connected.
Problem: The display does not come on or the
displayed segments are very weak
Solution:
a.- Check that the batteries are fitted correctly.
b.- Check the battery charge
c.- If they are run down change them
immediately
Problem: Display segments of a function read-
out are not visible or error messages for a
particular function appear.
Solution:
a.- Remove the batteries for 15 seconds and
then refit them correctly.
b.- Check the battery charge If they are run
down change the batteries
c.- If the above steps do not help then replace
the electronic monitor.
Avoid leaving the electronic monitor in direct
sunlight as this might damage the liquid crystal
display. Similarly, do not expose it to water or
knocks.
BH RESERVES THE RIGHT TO MODIFY THE
SPECIFICATIONS OF ITS PRODUCTS
WITHOUT PRIOR NOTICE
9