Carton Contents; Assembling The Handle; Battery Information - Black and Decker GFC1234 Manual De Instrucciones

•
Powerful and efficient permanent
magnet motor which gives effective
cutting and bagging in all reasonable
conditions and a low noise level.

Carton contents

The carton contains:
1 Lawnmower body
1 Handle assembly (3 parts)
1 Grassbox assembly (2 parts)
1 Spanner/scraper
1 Screwdriver
1 Battery
1 Battery cover
1 Charger
1 Safety key
1 Spare fuse
2 Wing nuts
2 Washers
2 Shaped washers
2 Bolts for upper handle
2 Bolts for lower handle
5 Screws for grassbox
1 Wiper (UK only)
2 Screws for wiper (UK only)
2 Cable clips
1 Instruction manual
•
Carefully unpack all parts.

Assembling the handle

•
Place the mower with its wheels on a
firm and level surface.
•
B1
Insert the handle bars into the openings
as shown in fig. B1, so that the curve
makes them widen at the top.
•
Secure each of the bars with a bolt and
shaped washer as shown. Securely
tighten the bolt using the spanner
supplied.
•
B2 Place the U-shaped upper handle bar
onto the bars as shown.
•
B3 Secure the upper handle bar using the
bolts, washers and wing nuts as shown.
•
Secure the cables to the handle using
the cable clips supplied.
Do not use any tools to tighten the wing nuts.
4
Grassbox assembly (Fig. C)
The grassbox comes supplied in two halves.
In order to assemble proceed as follows:
•
C1
Align the two halves of the grassbox as
shown.
•
Fit the two halves together with the 5
screws, using the screwdriver supplied.
Fitting the grassbox to your mower:
•
C2
The spring loaded rear flap is lifted and
the top of the grassbox is placed over
the mounting.
•
The rear flap can now be released to lock
the grassbox into position.
Removing the grassbox from your mower:
The full grassbox may be removed by raising
the grassflap, freeing the grassbox from its
mounting and resting it on the lawn. The
grassflap can be gently lowered, leaving both
hands free to lift the full grassbox.
Battery Cover Fitting
•
C3
Assemble battery cover provided
inserting hinge no.1 into mower body
then push home hinge no. 2.
Fitting the Battery strap
•
C4 Locate the battery and its carrying strap.
•
Fit the battery carrying strap as shown.
•
The strap should be kept on the battery
at all times.

Battery information

•
The battery in your cordless lawnmower
is a sealed lead acid system. The battery
employs an absorbed electrolyte and,
can therefore, be stored in any position
without fear of leakage.
The battery has been charged at the
factory, but you will need to recharge it
for a minimum of 30 hours before every
use to make sure it is fully charged.
•
For optimal performance the battery
should be recharged after each use.
•
For winter storage ensure:
•
The mower is fully charged before
storing.
•
The temperature of the storage
location is below 25˚C.
•
Storage duration is less than
6 months.
•
Always store your mower in a dry and
cool location.
•
Keep the mower and battery away from
water, heat sources (such as radiators,
heaters, stoves etc.), flames or chemicals.