Publicidad
Idiomas disponibles
Idiomas disponibles
Connect the outlet hose (without bending it) to a
drain duct with a minimum diameter of 4 cm.
Alternatively, rest it over a sink or tub; the free end
of the hose should not remain immersed in water.
A
and 100 cm above the ground ( see figure ).
We advise against the use of hose extensions.
Before inserting the plug into the electrical socket,
make sure that:
• the socket is earthed and complies with current
regulations;
• the socket can withstand the maximum load of
the appliance, which is indicated on the data
plate located on the inside of the door ( see
Description of the appliance );
• the power supply voltage falls within the values
indicated on the data plate on the inside of the
door;
• the socket is compatible with the plug of the
appliance. If this is not the case, ask an
authorised technician to replace the plug ( see
Assistance ); do not use extension cables or
multiple sockets.
Once the appliance has been installed, the power
supply cable and the electrical socket should be
easily accessible.
The cable should not be bent or compressed.
The cable should be checked regularly and
replaced by authorised technicians only ( see
Assistance ).
The special plastic
elbow* makes it easier
to find the best layout:
fix the elbow to the wall
securely in order to
prevent the outlet hose
from moving and
spilling the dirty water.
The part of the hose
marked with the letter A
should be between 40
The Company shall not be held responsible for any
incidents that occur if these regulations are not
observed.
After the appliance has been installed, immediately
before running the first wash cycle, completely fill
the salt dispenser with water and add approximately
2 kg of salt ( see Rinse aid and refined salt ). The
water may overflow: this is normal and is not a
cause for concern. It is also normal that the LOW
SALT* indicator light continues to flash for a few
cycles after the salt has been loaded.
width 60 cm
height 85 cm
depth 60 cm
12 standard place-settings
30 Kpa ÷ 1Mpa (0.3 ÷ 10 bar)
See appliance data plate
See appliance data plate
See appliance data plate
This dishwasher conform s to
the following European
Com m unity Directives:
-73/23/EEC dated 19/02/73
(Low Voltage) and
subsequent m odifications
-89/336/EEC dated 03/05/89
(Electrom agnetic
Com patibility) and
subsequent m odifications
-97/17/EC (Labelling)
-2002/96/CE (W EEE)
* Only available in selected models.
Publicidad
