Operation Details - Mitsubishi Electric PAR-SL101A-E Serie Manual De Instrucciones / Manual De Instalación

8. Wi-Fi interface setting

Operation details

Setting
Operation
No.
1 Connecting with
the router (WPS)
2 Connecting with
the router (AP)
3 Rebooting the
en
Wi-Fi interface
4 Initializing the
Wi-Fi interface
The indoor unit beeps and the operation indicator lamp blinks as below when the connection between the Wi-
Fi interface and the router is complete or failed.
When connection is complete
When connection is failed
20
This setting No. is for when connecting the Wi-Fi interface to the router using WPS. Select the setting No. and
press the button 5, then press the WPS button of the router within 2 minutes to complete the setup.
The operation indicator lamp near the signal receiver of the indoor unit repeats the following operation during the
process of setup: ON for 3 seconds, blinks twice, and OFF for 2.5 seconds.
Note: The indoor unit does not beep during the process of setup.
This setting No. is for when connecting the Wi-Fi interface to the router in AP mode. Select the setting No. and
press the button 5, then complete the network setup, within 10 minutes.
Make the network settings by referring to the manual for the cloud service.
The operation indicator lamp near the signal receiver of the indoor unit repeats the following operation during the
process of setup: ON for 3 seconds, blinks once, and OFF for 2.5 seconds.
Note: The indoor unit does not beep during the process of setup.
Select this setting No. when rebooting the Wi-Fi interface such as when the router cannot be connected to it
normally. Set up the connection again at 30 or more seconds after rebooting.
The indoor unit beeps and the operation indicator lamp blinks as below during the process of rebooting.
Select this setting No. when resetting the Wi-Fi interface to the factory setting such as when the air conditioner is
relocated or discarded or the user changes.
The indoor unit beeps and the operation indicator lamp blinks as below during the process of initialization.
Lamp OFF
1 sec.
Lamp OFF
1 sec.
Description
Beep Beep
Lamp
OFF
1st
2nd
0.1 sec.
Lamp ON Lamp ON
0.1 sec. 0.1 sec.
Beep Beep
Beep
Lamp Lamp
OFF OFF
1st 2nd 3rd
0.1 sec. 0.1 sec.
Lamp ON Lamp ON
Lamp ON
0.1 sec.
0.1 sec.
0.1 sec.
Beep (1 sec.)
Lamp ON
5 sec.
Beep Beep
Lamp Lamp
OFF OFF
1st 2nd
0.5 sec. 0.5 sec.
Lamp ON Lamp ON
0.5 sec. 0.5 sec.
Beep
Lamp
OFF
4th
0.1 sec.
Lamp ON
0.1 sec.
Beep Beep
Lamp Lamp
OFF OFF
3rd
4th
0.5 sec. 0.5 sec.
Lamp ON Lamp ON
0.5 sec. 0.5 sec.
Beep
5th
Lamp ON
0.5 sec.