Regulatory Information - Aritech ATS1136 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
Menu 4, System fault beep
In case a system fault occurs (no communication with the
control panel) the text "System Fault" appears on the display
and the buzzer will be activated until any key is pressed. The
setting Auto is used to enable this VdS required feature
automatically, if the language set in the control panel
corresponds with the countries, where VdS regulations are
obligatory. The setting can also be set to On or Off. The default
setting is Auto.
Menu 5, Defaults config
This option returns all keypad settings to the factory default
condition.
Menu 6, Card flash
This option enables and disables the blue LED flash when
a valid card is badged on the ATS1136 reader. The default
setting is Enable.
Menu 7, Card beep option
This option enables the beep sounded when a card is badged
on the reader and disables the beep. The default setting is
Enable.
Menus 8 and 9: Reserved for future use
Menu 10, Last card
This option displays the number of the last card badged on an
ATS1136 keypad.
Menu 11, Firmware version
This informational screen shows the keypad firmware version.
Specifications
Supply voltage
Maximum operating current
Normal operating current
Input (IN terminal)
Open collector output (OUT
terminal)
Wireless operating frequency
RF power output
Code combinations [1]:
5 digits
10 digits
ACE type (tamper protection)
Supported cards
Dimensions (W x H x D)
Weight
Operating temperature
IP rating
Maximum relative humidity
Security rating (EN62368)
P/N 466-5610-ML • REV A • ISS 27MAY21
8.5 to 13.8 VDC
190 mA at 13.8 VDC
30 mA at 13.8 VDC
Normally open (NO) contact. Max.
appearing voltage 13.8 VDC
13.8 V max. at 100 mA max.
Mifare 13.560 ±0.007 MHz
Less than 1 mW
100 000
10 000 000 000
B
Unsecure mode: Mifare Unique ID
(Classic 1K/4K, Desfire EV1, EV2)
Secure mode: Mifare Desfire EV1,
EV2
200 x 90 x 24 mm
(7.8 x 3.5 x 0.95 in.)
350 g
−10 to +55°C (22 to 127°F)
IP30
95% noncondensing
ES1, PS2, TS1
[1] Notes
When Duress functionality is enabled, 6 digits codes are required
There are no invalid code combinations
Notification
When printing or adding a customer logo on the ATS1136
keypad or its lens, take care to make use of RoHS compliant
materials and printing processes only.

Regulatory information

Manufacturer
PLACED ON THE MARKET BY:
Carrier Fire & Security Americas Corporation Inc.
13995 Pasteur Blvd
Palm Beach Gardens, FL 33418, USA
AUTHORIZED EU REPRESENTATIVE:
Carrier Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Product warnings
THESE PRODUCTS ARE INTENDED FOR SALE
and disclaimers
TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. CARRIER FIRE &
SECURITY CANNOT PROVIDE ANY
ASSURANCE THAT ANY PERSON OR ENTITY
BUYING ITS PRODUCTS, INCLUDING ANY
"AUTHORIZED DEALER" OR "AUTHORIZED
RESELLER", IS PROPERLY TRAINED OR
EXPERIENCED TO CORRECTLY INSTALL FIRE
AND SECURITY RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/ or scan the QR code.
Certification
EN 50131-1 System requirements
EN 50131
EN 50131-3 Control and indicating equipment
Security Grade 3, Environmental class II
Tested and certified by Telefication B.V.
VdS 2252 – Class C (G 120006)
Carrier Fire & Security hereby declares that this
device is in compliance with the applicable
requirements and provisions of all applicable rules
and regulations, including but not limited to the
Directive 2014/53/EU. For more information see:
www.firesecurityproducts.com
REACH
Product may contain substances that are also
Candidate List substances in a concentration
above 0.1% w/w, per the most recently published
Candidate List found at ECHA Web site.
Safe use information can be found at
https://firesecurityproducts.com/en/content/intrusi
on-intro
2012/19/EU (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
recyclethis.info
5 / 68

Publicidad

Tabla de contenido
loading

Tabla de contenido