Service; Construction And Repair; Warranty - D.A.S. Audio CT-1 MKIII Manual De Usuario

4.1.- CONSTRUCTION AND REPAIR

DAS controllers are manufactured with the highest technology and constitute an exponent of quality.
The devices basic parts are accessed easily during service or repair thanks to an effective interior design.
Materials and electronic parts used for their construction are all of the highest standards.
4.2.- REMARKS
4.2.1.- If the controller does not operate, or there appears to be a lack of electrical power, check the
AC cord connections.
4.2.2.- In case that there is no output signal, check the connector, and if a blown fuse is found,
replace it with a new one of the same value only. If the fuse continues to blow, send the device to your
nearest DAS service centre for inspection.
4.2.3.- Should a limiter indicator LED illuminate (CT-28V2, CT-28V3, CT-1000, CT-1500, CT-1800,
CT-2000) with no input signal, make sure a position has been selected on the corresponding limiter's mini
DIP switch, (see Appendix). If the problem is not corrected, send the controller to your nearest DAS service
centre for inspection.
The warranty certificate of your controller is found inside its package. It warrants the apparatus
against all manufactured defects.
In the event of breakdown or failure, we recommend the device always be sent to an authorised
service centre.
THE GUARANTEE IS VALID AS LONG AS THE DEVICE :
1. Has been installed adequately according to the instructions contained in this manual.
2. Has not been manipulated by unauthorised personnel.
3. Has not been misused, (understanding as such: negligent or improper handling), damaged by
accident or improperly mains connected.
D.A.S.
D.A.S. Audio, s.a.

4.- SERVICE

5.- WARRANTY

CT-1 (MKIII), CT-28V2, CT-28V3, CT-1000, CT-1500, CT-1800, CT-2000. US/008-03
16