DeWalt D25123 Traducido De Las Instrucciones Originales página 32

EN GLI SH
Indexing the Chisel Position
(fig. 2)
The chisel can be indexed and locked into 52
different positions.
1. Rotate the mode selector switch (d) until it
points to the "bit rotation" position.
2. Rotate the chisel in the desired position.
3. Set the mode selector switch (d) to the
"hammering only" position.
4. Twist the chisel until it locks in position.
Inserting and Removing SDS Plus
Accessories (fig. 3)
This tool uses SDS Plus ® accessories (refer to the
inset in fig. 3 for a cross-section of an SDS Plus
bit shank). We recommend to use professional
accessories only.
1. Clean and grease the bit shank.
2. Insert the bit shank into the tool holder (f).
3. Push the bit down and turn it slightly until it fits
into the slots.
4. Pull on the bit to check if it is properly locked.
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the tool holder.
5. To remove a bit pull back the tool holder locking
sleeve (l) and pull out the bit.
WARNING: Always wear gloves when
you change accessories. The exposed
metal parts on the tool and accessory
may become extremly hot during
operation.
Fitting the Side Handle (fig. 4)
The side handle (j) can be fitted to suit both RH- and
LH-users.
WARNING: Do not use the tool without
the side handle properly assembled.
1. Loosen the side handle.
2. For RH-users: slide the side handle clamp
over the collar behind the tool holder, handle at
the left.
For LH-users: slide the side handle clamp over
the collar behind the tool holder, handle at the
right.
3. Rotate the side handle to the desired position
and tighten the handle.
30
Setting the Drilling Depth (fig. 5)
1. Insert the required drill bit as described above.
2. Press the depth stop clamp (k) and keep it
depressed.
3. Fit the depth adjustment rod (i) through the hole
in the depth stop clamp.
4. Adjust the drilling depth as shown.
5. Release the depth stop clamp.
Forward/reverse Slider (fig. 6)
1. Push the forward/reverse slider (c) to the
®
RH-side for forward (RH) rotation. See arrows
on tool.
2. Push the forward/reverse slider (c) to the
LH-side for reverse (LH) rotation.
®
WARNING: Always wait until the motor
has come to a complete standstill
before changing the direction of rotation.
Fitting the Chuck Adapter and Chuck
D25123
1. Screw the chuck onto the threaded end of the
chuck adapter.
2. Insert the connected chuck and adapter in the
tool as though it were a standard SDS Plus
3. To remove the chuck, proceed as for removing
a standard SDS Plus
WARNING: Never use standard chucks
in the hammerdrilling mode.
Replacing the Tool Holder with the
Chuck (fig. 7)
D25124K
1. Turn the locking collar (h) into the unlocking
position and pull the tool holder (f) off.
2. Push the chuck (m) onto the spindle and turn
the locking collar into the locking position.
3. To replace the chuck with the tool holder, first
remove the chuck the same way as the tool
holder was removed. Then place the tool holder
the same way as the chuck was placed.
WARNING: Never use standard chucks
in the hammerdrilling mode.
Replacing the Dust Cover (fig. 3)
The dust cover (g) prevents dust ingress into the
mechanism. Replace a worn dust cover immediately.
® bit.
® bit.