Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Cordless Spotlight Compressor with Emergency Car Starter
2. Make sure locking thumb lever is at up position. If necessary, use
valve stem adapter. Insert stem connector to valve stem and press
down the locking thumb lever to engage. Make sure connector is
pushed to valve stem as far as possible.
3. Set the compressor on/off switch to "ON" by changing from
position "O" to "—".
4. Monitor pressure on air pressure gauge.
5. When desired pressure is reached, turn off the compressor.
6. Turn the locking thumb lever to up position and remove stem
connector from valve stem. Also remove the valve stem adapter
7. Store the compressor hose in its storage compartment.
Note: In the event that the tire is completely flat, raise the vehicle
using a recommended jack before inflating the tire.
B. To Inflate Plastic Inflatable Products
(recreational balls, air mattresses, rubber rafts, etc.):
1. Check manufacturer's specification on item to be inflated for
correct inflation pressure.
2. Open the air hose storage compartment (lifting up the spotlight
lantern) and extend the air hose.
3. Make sure locking thumb lever is at up position. If necessary, use
valve stem adapter. Insert stem connector to valve stem and press
down the locking thumb lever to engage. Make sure connector is
pushed to valve stem as far as possible.
4. Insert other end of valve stem adapter into inflatable air valve stem
as far as practical.
www.wagan.com
5
User's Manual—Read before using this equipment
5. Set the compressor on/off switch to "ON" by changing from
position "O" to "—".
6. Monitor pressure on air pressure gauge.
7. When desired pressure is reached, turn off the compressor.
8. Turn the locking thumb lever to up position and remove stem
connector from valve stem. Also remove the valve stem adapter.
9. Store the compressor hose in its storage compartment.
Using the Jumper
IMPORTANT: Before attempting to start vehicle, this unit must be removed
from the vehicle's 12V socket.
1. Turn off all lights and all other accessories (radio, etc) in the
vehicle. Tip: keep one small vehicle light or dial turned on to aid in
determining if the battery is charging.
2. Make sure the vehicle's 12V Socket is clean and free of debris.
3. Put the lighted end of the Male-to-Male Car Power Cord into the
vehicle's 12V socket
4. Put the end of the Male-to-Male 12V Car Power Card with no LED light
into unit's 12V socket.
5. The Indicator Light on the 12V connector will illuminate indicating
that the power is flowing. The light or dial left on in the vehicle should
brighten as well. Leave the unit connected to the vehicle's 12V socket
for about 35 minutes.
6. If the light or dial does not brighten, turn the ignition key ONLY as
far as the accessory position (see vehicle owner's manual.) In some
vehicles, this is necessary for the 12V socket to operate.
©2010 Wagan Corporation
All Rights Reserved
Wagan and wagan.com are trademarks used by Wagan Corporation
6
Publicidad
Tabla de contenido
